Flipline Blog
NEW FLIPDECKS PREVIEWS GAMES Q&A UPDATES FAN ART CONTESTS

Wendy’s Wheels: The JackRabbit!

comments Comments Off
By , January 10, 2024 3:55 pm

 

Hey Everyone!

Welcome back to Wendy’s Wheels! Here we showcase the amazing karts created by Wendy at the Greasy Gear Garage in Maple Mountain.

This week’s exhibit is a custom kart created for Ally Kabam called… The JackRabbit. The kart is an enchanting skiff design complemented by an innovative hydro-booster that enables it to achieve sudden speed surges while gliding across the water. Along with the kart, Ally also commissioned Wendy to construct a boat hoist behind her shop. Ingeniously integrated with a concealed trap door, this mechanism enables Ally to execute swift and dramatic vanishing acts during her captivating performances.

 

Comments

Powered by Facebook Comments

Sneak Peek: Freezer Burn and Mushy Paletas

comments Comments Off
By , January 9, 2024 3:11 pm

Hey Everyone!

This week we are chillin’ (ha) in the Chill Station for a bit longer as we explain what happens to your paleta while it freezes in the mold.

It is of the utmost importance that you keep an eye on your paleta while in the deep freezer. If you take your paleta out too soon, you could end up with a sad looking excuse for a frozen treat. On the flip side, if you leave your paleta in the deep freezer for too long, it will get a bad case of freezer burn.

But what happens if you only let the mold sit in the deep freezer for a few seconds? Well, let’s just refer to the image below.

 

Be sure to check back here for more Sneak Peeks of Papa’s Paleteria To Go!

 

 

Comments

Powered by Facebook Comments

Sneak Peek: The Chill Station!

comments Comments Off
By , January 2, 2024 1:20 pm

Hey Everyone!

In our last preview, we showed how you would properly fill up a paleta mold. This week we move onto the Chill Station!

Once you arrive, the mold will slide into view at the bottom center of the station. Once you are ready, drag the mold to an available slot inside the deep freezer.

Once the mold has settled in place, its contents will slowly chill until they are completely frozen solid. During this time, you will want to keep an eye on the mold’s built-in temperature gauge.

Once the proper temperature is reached, you will drag the mold out of the deep freezer and onto the green conveyor. There, it will quickly open, revealing a perfectly frozen paleta before sliding away to the Top Station.

 

Be sure to check back here for more Sneak Peeks of Papa’s Paleteria To Go!

 

 

Comments

Powered by Facebook Comments

   Home  |   Games  |   Apps  |   About  |   Contact  |   Terms of Use  |   Privacy Policy  |   Blog  |   Forum  |   Shop  |  Free Games for your Site  |  Flipdeck  |   © 2024 Flipline IDS LLC